48W/60W/72W Constant Voltage LED Driver

Products > LED Driver > 48W/60W/72W Constant Voltage LED Driver

48W/60W/72W Constant Voltage LED Driver

DC OUTPUT: 6 Dupont interfaces
Min.Order Quantity: 5K PCS
Port: ShenZhen
Payment Terms: T/T,Western Union,PayPal
Porudct time: 10 to 15 working days or depending on the order
Package: Carton
2 years warranty
shared:
SPECIFICATION
OutputSPEC MODEL NO.VP-1206000LEDSVP-2403000LEDS
DC VOLTAGE12V24V
RATED CURRENT6A3A
CURRENT RANGE0-6.0A0-3.0A
RATED POWER(MAX)72W72W
RIPPLE & NOISE(MAX)1%1%
VOLTAGE TOLERANCE  ±5%±5%
LINE REGULATION1%1%
LOAD REGULATION±5%±5%
SETUP,RISE,HOLD UP TIME1000ms, 50ms, 12ms  at full load
InputVOLTAGE RANGE 100-240V AC
FREQUENCY 50/60HZ
EFFICIENCY  80%~82%80%~82%
AC CURRENT0.2A / 100VAC
INRUSH CURRENT (max.)50A / 230VAC 
LEAKAGE CURRENT (max.)0.25mA / 240VAC
ProtectionOVER LOAD>110% rated output power
Protection type:
   Hiccup mode,recovers automatically after fault condition is removed
OVER VOLTAGE>120% rated output voltage
Protection type : Shut off o/p voltage, clamping by zener diode
ENVIRONMENTWORKING TEMP.0 - +40℃  
WORKING HUMIDITY 20% ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY-20 - +85℃,10% to 95% RH
TEMP. COEFFICIENT0.03% /°C(0 ~ 40℃ )
VIBRATION10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY &
   EMC
SAFETY STANDARDSEN-62368-1 Approval
WITHSTAND VOLTAGEI/P-O/P:3KVDC
ISOLATION RESISTANCEI/P-O/P:100M Ohms / 500VDC / 25 / 70% RH ℃
EMC TEST STANDARDCompliance to EN61347-1:2008+A1:2011+A2:2013 EN 61347-2-13:2014 
Compliance to EN61000-3-2,3  EN55024:2010
OTHERSMTBF780Khrs min.      MIL-HDBK-217F (25 )
DIMENSION164*65*25mm
PACKING200g/pc; 100pcs/carton
NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25of ambient temperature.°C
2. Tolerance : includes set up tolerance, line regulation and load regulation.
3. Derating may be needed under low input voltage. Please check the static characteristics for more details.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will beaffected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
 5. When applying DC voltage for input, please connect the brown input wire to the positive side whereas blue input wire to the negative side.

Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit